Upgrade kit for Pharos 1.0 (with COARSE thread axle - 13 TPI) to bring it up to the current 2.0. Once installed your coarse thread Pharos 1.0 will have FINE thread axle, collar & handle, as well as the upgraded grounds removal! (Note - your original top cap will not fit, and we do not have a replacement - sorry!)
If you are not sure which you have, take the top cap off your axle, and measure 1", and count the threads - 13 threads per inch = COARSE Contains:
- Decal Index Sticker for top plate
- Adjustment Collar with screw (to fit new axle)
- Handle (to fit new axle)
- Lower Bushing Support with Bushing
- 3 Plate Springs
- Spring Plate
- Catch Cup
This kit is for Pharos 1.0 COARSE thread Manual Coffee Grinders only - check for the serial number on the bottom of your grinder, and check the axle top threading to be sure! These were hand made, in Idaho, and all were serial numbered. Video instructions on installation are available below, or on youtube.
If your grinder has plastic bolt covers, we recommend replacing them with aluminum bolt covers (sold separately).
Our earliest Pharos grinders had a coarse pitch thread at the top of the axle shaft - 1/2" x 13 TPI thread. Later version has FINE thread - 1/2" x 20 TPI thread. This threading is critical to match the threading on the handle and top cap.... We are a bit chagrined to not have records that tell us when we changed, or which grinders have which thread... The records of that, seem to be in Doug's head, and inaccessible through any means of data retrieval... So, the best thing to do is check your axle threading before you order - it's simple to do.